Valve Adjustment Screw 10mm Heritage Parts Centre AU

Gas Valve Adjustment Screw. Valve Adjustment Screw and Nut 8mm Californian Classics The adjustment screw is located near the gas valve on the pilot assembly, if the control has this adjustment feature. Which is basically, installing a nat gas spring under the adjusting screw you have been.

To adjust the height of the pilot flame, turn the flame adjustment screw until the flame is from 1 1/2 to 2 inches (3.8 to 5.1 centimeters) high Adjust the low-pressure valve to 1.6 WC for natural gas

Original Equipment Valve Adjust Screw

*if no stop can be felt remove gas valve and ensure butterfly valve is open all the way (no white seen) (fig.8). When you have it, slip a flathead screwdriver into the valve By turning this smaller screw counterclockwise, the flame can be increased

SFT 199 Converting from Natural Gas to Propane P802. This ensures proper fuel-to-air ratio at higher altitudes. The adjustment screw is located near the gas valve on the pilot assembly, if the control has this adjustment feature.

Expert Answers for Old Payne Furnace and Pilot Light Adjustments. It would need to be converted back to a nat gas valve If you turn the adjustment screw for pressure in a clockwise direction, it will give more pressure.